摘要：无机富锌底油漆的使用主要是利用环氧树脂、锌粉成分以及硅酸乙酯的原材料性能发挥作用。一般在施工的过程中，尽量要避免一些小问题的出现，尤其是表面粗糙这样的现象，其实只要稍加注意是可以避免出现的。

　　Abstract: the use of the bottom of the inorganic zinc paint mainly using epoxy resin, zinc powder composition and ethyl silicate materials properties play a role. Generally in the process of construction, as far as possible to avoid the occurrence of a few small problems, especially the phenomena such as rough surface, in fact, as long as pay attention can be avoided.

　　无机富锌底油漆漆膜表面粗糙的原因

　　漆膜表面粗糙具体表现实在无机富锌底油漆漆成膜之后表面会有不平整、沙粒凸起或者小气泡等现象。原因是主要因为漆料内颜料过多，颗粒太大。漆料本身不干净，混油杂质没有过筛就投入使用等等。当然，气泡现象的出现一般就是因为漆内气泡没有完全分散排除，表面不洁净有残留物在其中，这样灰尘杂物就容易造成表面粗糙。

　　Rough surface film embodied really inorganic zinc-rich paint bottom paint film after surface will be uneven, the phenomenon such as sand bump or small bubbles. Reason is mainly because of the paint of excessive pigment particles is too big. Paint itself is not clean, mix oil impurities without sieve is put into use, and so on. Bubble phenomenon in general, of course, is not fully spread out, because paint inside bubbles on the surface of unclean in which residues, such dust debris would be easy to cause surface roughness.

　　无机富锌底油漆防止表面粗糙的办法

　　确保无机富锌底油漆产品的质量是前提，其次在使用前必须经过细筛进行调和筛选，确保均匀无气泡后在使用。接下来要注意物体表面清理干净，保持平整、光洁，和干燥。之后按照施工顺序，在无灰尘无杂物的环境中进行涂刷工作。

　　Ensure that the bottom of the inorganic zinc paint quality of the products is the premise, the second before use must be conducted through a fine screen harmonic filter, ensure uniform in no bubbles after use. Next, should pay attention to clean up the surface, keep smooth, bright and clean, and dry. According to the construction order, after no dust and debris environment besmear to brush work.